31K-Lawgiver-M hardware
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
My take on Lawgiver MKII from the 1995 film
- Rating
- 0 / 5
- Likes
- 20
- Downloads
- 44
- Makes
- 0
- Views
- 561
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Outdoor Sports
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
My take on the Lawgiver MKII from the 1995 film Judge Dredd (iirc). Uses the 31K-M from Misplaced Moose as a base, just created a new shell.
Assembles pretty much the same as any 31K, with the exception the cord used for the sear is routed thru the front of the slide instead of on top, went this way to clean the top up for the small rail. (see the last pic). Custom mag still uses 1x screw to assemble, holds 8x darts.
I typically print everything 4 walls for everything, 30% infill body/frame pieces and 100% infill on anything internal. All parts should load into the slicer in the orientation I printed them.
Hardware kits can be found on Misplaced Moose's website. I always recommend tossing in an extra pack of 4-40 screws into the carts, just a couple of bucks for 20x and having spares is handy. And also choose 6 bearing option.
https://moosemodshop.com/
If you're wanting to go the heat inserts route, you'll ALSO need 13x voron spec heats inserts (m3 x 4mm x 5mm) and 13x m3x8mm buttonhead screws. (this version is what's pictured)