Floating Painting Frame L-Moulding Glue-Up Clamp
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Make your own floating painting frame L-moulding: clamps two flat strips so edges and faces glue up square and aligned.
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 0
- Makes
- 0
- Views
- 19
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Tools
- License
- Creative Commons — Attribution
Most floating frame jigs help you join the corners of ready-made L-moulding. This clamp is for the step before that: making the L-moulding yourself from two flat strips of timber. Handy when you realise L-moulding is expensive to buy and you want to use your own timber anyway, or just want a custom size.
The good, visible face piece sits against the clamp backs. The hidden back support piece that screws into the back of the painting, which can be a cheaper grade of timber, is glued to the bottom of its face to create the L. You pinch both pieces up against the clamp's inner upright face to line up the edge and face of the two parts, then tighten the screw with a hex key. Space several clamps along the length and leave the glue to cure.
Note: There is no need to over-tighten the bolts when clamping!
For the paintings I usually frame (~1000 x ~750mm), I use 4x clamps for the long sides and 3x for the short sides, totally 24 clamps required to glue all at once.
Note: I have used pipe clamps in the past for this, but I find they don't come out square and it's more difficult and awkward getting the face/edges to be aligned. They're also significantly more expensive to have 24 of them!
Features
Lines up both the edge and the face of the joint, so the L-profile comes out square
A swivel cap spreads the clamping pressure and won't twist the timber as you tighten
Small and quick to print, so you can make a batch for long lengths
Clamp supports a maximum of < 45mm which is the sum of the width of the supporting strip timber and the thickness of the good face timber). Normally I use 8mm thick timber for both pieces and have the support piece 35mm wide, totally 43mm.
Hardware (per clamp)
1 × M3 × 15 mm (or longer, depending on frame width) socket head screw
M3 Allen key
Assembly
Thread the screw down through the hole in the top arm.
Screw the swivel cap onto the screw tip.
Snap the jaw onto the screw shaft so it houses over the swivel cap.
Print notes
Material: I use PETG-CF for the clamp body - better to be a strong material. PLA+/tough should work too. Use anything for the other parts - I use PLA+.
Layer Height:
Swivel Caps: I print these with a 0.2mm nozzle at 0.04mm layer height so the threads get printed nicely.
Clamp Body: When using PETG-CF, I print with hardened steel 0.6mm nozzle at 0.25mm layer height. The threads within the threaded hole don't really print but I've found it doesn't matter as the layer lines serve the same purpose.
Wall count: 4 or more.
Supports: None required.
