Nerf Stampede Picatinny Rails
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Picatinny adapters for a foregrip, optic, and side rails on the Nerf Stampede
- Rating
- 0 / 5
- Likes
- 26
- Downloads
- 8
- Makes
- 0
- Views
- 182
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Toys & Games
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Nerf Stampede Picatinny Rails
Description:
Picatinny adapters for a foregrip, optic, and side rails on the Nerf Stampede
Materials:
3x M3 washer
5x M2.6x16mm self-tapping screws
Printer Settings:
At least 4 walls, 25% gyroid infill
Instructions:
1. Make sure the parts are clean. The rails, especially the sight rail, can be a tight fit. I tapped mine on with a rubber hammer before securing it.
2. Install the side rails
a. Take the blaster apart - there are between 30 and 40 screws so be careful not to lose any.
b. There are more screws on the inside that must be removed to take of the front section on each side that covers one of the screws for the side rail.
c. Unscrew the side rail.
d. Remove the old rail and add the new. It will only fit one way.
e. Secure with the same screws.
f. Repeat on the other side for the other side rail.
3. Install the lower rear rail
a. Remove the 2 screws from the lower rear rail (the one closer to the magazine well).
b. Slide the Picatinny Rail over the lower rear NStrike rail.
c. Secure with 2 of the M2.6x16mm screws
4. Install the upper rear rail
a. Remove the 3 screws from the upper rear NStrike rail (on top of the carry handle).
b. Slide the Sight Rail over the upper rear NStrike rail. Be sure the screw holes line up.
c. Place a M3 washer around each of 3 remaining M2.6x16mm screws and then screw into the carry handle to secure the rail.
As with any blaster modification, you bear sole responsibility with any problems from any modification you perform.