Anker 313 Qi Charger Holder
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
I have the Anker 313 Qi wireless charger for my iPhone 13 and needed a way to hold the phone on it better for charging.
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 0
- Makes
- 0
- Views
- 13
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Office
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
DISCLAIMER: This was made for an iPhone 13 (Not Pro or Pro MAX) with a phone case on. All the measurements and tests were done with that model. You will probably have to modify it to fit your specific phone.
I use the Anker 313 Qi wireless charger and I like it but have trouble locating the phone on it to make sure it will charge. After multiple times of thinking the phone was charging only to find it not hours later, I decided to do something about it.
I wanted a slightly angled holder but not a fully upright holder. I wanted to be able to place it vertically or horizontally. And I wanted it to be heavy.
I made a few prototypes before landing on this. The Qi charger is a slight press fit which I wanted, and the phone works both ways. I made it hollow so I could fill the back with weights, and I used BBs and resin. Weighs about 2 pounds, I didn't want it sliding around my desk.
Definitely could have just bought a new charger or whatever, but I was bored and we don't do this because it was easy; we do it because we thought it would be easy.
I printed it out of PLA and seems to be holding up well, it stay in my office out of the elements and away from the sun.