O.S. Bomba Costume Pack 1: Samurai and Magical Girl
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A Costume pack for your O.S. Bomba. (2 new keys, a wand, a katana and a head protector.)
- Rating
- 0 / 5
- Likes
- 3
- Downloads
- 12
- Makes
- 0
- Views
- 80
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Action Figures & Statues
- License
- Creative Commons — Attribution
Dress up your O.S. Bomba marble launcher with these Samurai and Magic girl themed Costume packs!
Choose your colors, mix and match, make it YOUR O.S. Bomba!
Samurai Gear Costume Pack:
You'll get an modified "head upper" that'll fit the Head armor + the moon "Head key".
Also included is a katana fit for a warrior (albeit a tiny one)
Magical Gear Costume Pack:
Make your Bomba the star of the battlefield with the new star "Head key".
Don't forget the magic wand, the key to casting spectacular spells!
Print Instructions:
there are two .3MF's included in case you are feeling lazy.
One .3mf for Bambu studio + p1p printer + PETG,
One .3mf for Snapmaker Orca + Snapmaker U1 printer + PETG
Else, you should probably use the STL files and manually configure the settings.
Enable supports/skirts/brims when necessary (each part will have files notes in the "Files" tab)
Do not use "Classic" wall generator, use "Arachne" instead. (Should be in the Quality tab)
Setting "Base pattern spacing" to 1.2mm(or smaller) will help with sag. (Support Tab>Advanced)
Don't use Tree supports, use "normal" supports
STL's should already be in optimal orientation
Samurai Instructions:
For a preassembled Bomba, remove the Base Head Key and Upper Head Cap before proceeding
First, you'll wanna install the new "Head upper" that supports a front accessory. If you chose the version that has an antenna slot, you can add an antenna if you want.
Slide the FrontHeadGaurd into the front accessory slot, then you can install a Head Key of your choice.
Equip the katana into one of the hands holes.
Magical Instructions:
For a preassembled Bomba, remove the Head Key before proceeding. Check how well the wand fits in the hand of the Bomba, if its too loose or too tight, you'll wanna mess with print scaling until you get a nice fit. I found that even when using PETG from the same manufacturer, different colors had different fit.
First, you'll wanna install a "Head Key" of your choice.
Next, you'll wanna assemble the wand. A good thing to do beforehand is to make sure that the square peg of WandSideB fits nicely into the square hole of WandSideA. If it's too tight, scraping it with a knife or filing it down will help fix the fit. Else if it's too loose, you'll probably need to prepare some glue to help with the fit.
Install WandsideA into the WandHandle. Makes Sure to double check the orientation of the star before installation!
Install WandsideB into the other side. Make sure the orientation of the star is correct! I recommend using glue for a more permanent finish.
Equip the wand into one of the hand holes.
ALT PARTS + STP Notes:
BombaHeadUpper ALT(FrontAcc+Mag): In addition to the front accessory compatibility, this version of the "Head upper" also removes the antenna and makes space for the installation of a B-daman Plug-in magazine.
STP Parts are not oriented in optimal orientation for printing. STP Parts were Exported from Rhino3d and might have some errors. Hopefully it's easier to modify than STL files!