SKÅDIS pocket for Heatmiser neoHub v2
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Calipered pocket that holds a Heatmiser neoHub v2 on IKEA SKÅDIS, port edge down, no rattle.
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 0
- Makes
- 0
- Views
- 8
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Organizers
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
A pocket for the Heatmiser neoHub v2, measured at about 172 mm long, 91.6 mm front to back and 27.2 mm thick (the datasheet says 25.5, which is too thin!). The hub sits base to the board with its rear edge (mini-USB power and Ethernet) DOWN through an open floor, so the leads drop straight out, and the LEDs and button face out. Front lips hold it in and a sprung bump in the back plate stops rattles.
Hangs on 2 hook bars (included). Print upside down (open top on the bed), no supports. In hub_pockets.scad set part = "neohub_print" to export it, or add your own hub to the table at the top.
Print settings: PETG, 0.2 mm layers, 4 walls, 25% gyroid, no supports.
Editable OpenSCAD source: https://github.com/PrimroseHA/skadis-network-mounts
Other parts in my SKÅDIS network rack (all hang on the same hook bars):
Hook bars (start here): https://www.printables.com/model/1866142
TP-Link Omada POE380S injector: https://www.printables.com/model/1866145
TP-Link TL-SG1024D 24-port switch: https://www.printables.com/model/1866147
Samsung SmartThings Hub v3: https://www.printables.com/model/1866154
Lightwave Link Plus L2: https://www.printables.com/model/1866155
TRIGKEY G4 mini PC: https://www.printables.com/model/1866149
2 x UGREEN 2.5" SSD enclosures: https://www.printables.com/model/1866157
Sonoff ZBDongle-E Zigbee dongle: https://www.printables.com/model/1866160
Wall spacers and caps: https://www.printables.com/model/1866187