Modular Pot Lid & Cutting Board Rack – Snap-Together, No Supports
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Modular rack for pot lids and cutting boards. 2 slots per module, dovetail joints, 30/45 mm slots, no supports.
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 8
- Makes
- 0
- Views
- 27
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Kitchen
- License
- Standard Digital File License
A modular rack that keeps pot lids and cutting boards upright in a cabinet or on the counter. Each module has two slots – print as many as you need and slide them together into one long rack.
Modular: dovetail joints on both rails – slide the next module on from the top, it locks in place. Any number of slots.
Two slot widths: 30 mm (cutting boards, flat lids) and 45 mm (lids with tall knobs). You can mix them in one row.
Lids don't roll: the lid rim rests on two rails (front and back), so a round lid sits steady.
Open floor: only two rails under the slots – less plastic, water drains, easy to wipe.
Tapered 58 mm fins with rounded tops: boards and lids slide in easily.
Size per module: 30 mm version 80 × 64 × 58 mm, 45 mm version 110 × 64 × 58 mm (incl. joint).
Print settings
Orientation: as supplied (standing, rails on the bed). No supports, no brim.
0.20 mm layer, 2–3 walls, 15% infill. PLA or PETG (PETG next to the sink).
Bambu A1, PLA, 0.20: 30 mm – 1 h 08 min / 25.1 g; 45 mm – 1 h 11 min / 27.2 g per module.
Joint clearance 0.2 mm per side. If your printer runs tight, sand the dovetail tongue lightly.
Designed from scratch by bezbajzlu.