Sky Watcher Virtuoso/Heritage 150P magnetic hood
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This is a magnetically attached hood for Sky Watcher Virtuoso and Heritage 150P telescopes.
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 7
- Makes
- 0
- Views
- 76
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Physics & Astronomy
- License
- Creative Commons — Attribution
This is a magnetically attached hood for Sky Watcher Virtuoso and Heritage 150P telescopes. It is designed to prevent leakage from nearby light sources. For maximum effectiveness it should be paired with my clip-on shroud: https://www.printables.com/model/1569521-sky-watcher-heritagevirtuoso-150p-clip-on-shroud
The hood is designed to be printed with foaming TPU. I used Siraya Tech Flex TPU Air 95A with the following settings:
Bed temperature - 65C
Nozzle temperature - First layer 230C, then 260C
Flow Rate - First layer 90%, then 40%
Wall/top/bottom thickness - 1.6mm
Infill - 40%
Retraction disabled
Everything else was normal TPU settings.
***Make sure you put down a layer of purple glue stick or you WILL ruin your print bed.***
The magnets are 19x1.6mm adhesive-backed discs. They fit flush in the pockets created by the end of the trusses.
Telescope magnet installation:
Heat your print bed to 65C.
Without removing the protective film, place the magnets adhesive side down on the print bed. Make sure they have the same polarity.
While the magnets are warming, clean the truss pockets with isopropyl alcohol and a cotton swab.
One at a time, remove the magnets from the print bed, peel the protective film and place them in the pockets. The warmed adhesive should stay pliable for a few seconds, giving you time to center the magnet in the opening.
Hood magnet installation:
Remove the adhesive backing from the magnet (you can scrape it off with your fingernail).
Insert magnet into pocket, making sure it is in the correct polarity to align with the magnets on the telescope.
When complete, the hood should easily snap into place and stay in the correct position. Remove the hood by pulling up on the tab.
Note: There may be some stray bits of foam on the inside surface of the hood after printing. These are easily removed with a pair of flush cutters.
