Vertically printed Woose barrels
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Tighter bore & printed vertically
- Rating
- 0 / 5
- Likes
- 6
- Downloads
- 6
- Makes
- 0
- Views
- 128
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Outdoor Toys
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Vertical barrels and built in brim for easier printing (i hope). Ive printed 18 barrels with this built in brim with no issues.
Ive tested a Hobo-barrel (play on robo-barrels) setup with long draw Woose and 1/2" cord and averaging 360-380 fps, with half darts and tpu head, did get one dart to 396.7, which is just absurd. Will do more testing when NF strikes come in for full length numbers
If ya wanna try the Hobo-barrel set-uo, the brim side is where the dart should exit and the side with the deeper chamfer should be where the dart enters, just use the dart jointer, 19.2 barrel on the magwell side and 19.4 on the muzzle side...
Ive been printing these with 4 walls, 20% infill, 0.6 outside wall line width and 0.5 inside wall line width and taller layer heights, simply for faster printing