UM690 Case Remix
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
An easier to print version that uses heat inserts to make it easier to open and close.
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 2
- Makes
- 0
- Views
- 25
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Computers
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Why
I printed the original design, but found it very difficult to both print and assemble. I originally tried prompting for a rails system to replace the posts, but quickly realized the PCB was never designed for this use case and could interfere with components, also the tolerances weren't good and it required even more supports. I started out with joining the left, right, back and bases, and originally wanted rails for the top and the front, but this proved difficult to do well.
Finally I arrived at the slide front to back like a conventional SFF style case. I had m3 heated inserts so specified them instead of just screw holes. I used a 92mm arctic PWM fan for my tests and a manual speed controller. With the stock controller temps became much better because of the less restricted air flow, and it was possible to maintain near 60fps @ 72C on the CPU in CEMU Wii BotW with some drops from time to time.
With the 92mm fan at 60% duty cycle, CPU temps dropped down to 65C and power consumption rose to peaks of 70W for both the GPU and CPU. BotW had a solid 60fps during a 1 hour session just playing the game normally.
I'm still waiting for parts to replace the microfit CPU fan connector and remove the blower fan and fully switch over to the 92mm fan, but I am content with this case and how it works and it is very easy to open a close; my original primary goal. This case helps the UM690 motherboard reach it's full potential as the original case air flow was far too restricted and caused 780M GPU to throttle.
The microfit connectors finally arrived and I made a custom cable to replace the stock fan. In the end what worked best for me was to completely remove the stock fan and all the tape holding it onto the heatsink and pipes. I had to tune the BIOS settings. What worked for me was 60C <-> 80C, and fan curve 3. That prevented rapid cycling between high and low fan and kept the fan at a constant rate. I can now sustain performance during emulation and the box isn't too loud.
For a little bit of extra fun, printing the power button in clear PETG would let the LED shine through.
Printing
optimized for 0.6mm nozzle with 0.3mm layer height
only tested in PETG. PLA would probably melt. ASA or ABS will be fine.
no supports required
print as oriented in the 3mf
tested on an enclosed Flashforge AD5M using the hardened 0.6mm nozzle and Basic PETG
attach your own feet of your choosing to let the bottom vents work properly
LLM Usage
I used claude (sonnet 5.5) to make these changes. I am still a noob at CAD design and while I knew what changes I wanted to make I am not skilled enough to use OnShape to make them. Probably in all this took 2 sessions and about 1 million tokens to complete. Please remix to your hearts content.
Photos are of Front, Rear and Bottom views. All ports line up and are fully usable.