HP Z440 RAM Cooler – Tilted 92 mm Fan Duct (clip-on)
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Clip-on RAM cooler for the HP Z440 that fits a standard 92 x 25 mm fan over each DIMM bank.
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 10
- Makes
- 0
- Views
- 94
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Computers
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Clip-on RAM cooler for the HP Z440 that fits a standard 92 x 25 mm fan over each DIMM bank. A flat 92 mm fan does not fit between the CPU cooler and the chassis, so the fan sits at an angle on a wedge-shaped duct that directs the air down between the memory modules.
Remix of the 60 mm Z440 RAM cooler – the clips that snap onto the DIMM slot latches are unchanged from the original.
Parts
- Rear bank: bracket + duct (60° tilt)
- Front bank: bracket + split-flow duct (65° tilt). A divider sends roughly half the air down to the RAM and the rest through the open back wall into the CPU cooler fan, so the CPU intake is not blocked.
Each bracket is engraved FORAN (front) or BAK (rear) and has an arrow marked CPU that must point toward the CPU cooler.
Printing
- Bracket: flat side down, clips up
- Duct: open bottom on the bed
- No supports needed
- PETG or ABS recommended (the rear duct sits in the CPU cooler exhaust)
Hardware per bank
- 1x 92 x 25 mm fan
- 4x standard fan screws
- 2x zip ties
Assembly
1. Screw the fan to the duct through the two lower holes, from inside the duct.
2. Secure the two upper holes with zip ties.
3. Screw the duct to the bracket through the end tabs.
4. Clip the bracket onto the DIMM slots.
Notes
- Designed around the stock HP CPU cooler. Check clearance in your own machine before printing both sets.
- On the rear bank the fan can be mounted reversed, pulling air up past the RAM and toward the rear exhaust fan.
- Fans can be powered from the 6-pin MEM FAN header (GND, +12 V, TACH 1, TACH 2, PWM 2, PWM 1). 3-pin fans work with the PWM pins left unconnected, but run at full speed.