Logitech Pebble 2 K380s Keyboard Riser Feet
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Give your Logitech Pebble 2 K380s a more elevated typing angle with these simple feet
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 6
- Makes
- 0
- Views
- 40
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution — Share Alike
Logitech Pebble 2 K380s Keyboard Riser Feet
Give your Logitech Pebble 2 K380s a more elevated typing angle with these simple feet.
This model includes 4 feet designed to replace the original rubber feet on the bottom of the keyboard. The new feet raise the keyboard and provide a more comfortable and ergonomic typing position.
Printing
No supports required
Nozzle size: 0.4 mm or smaller recommended
Horizontal printing recommended, with a brim
I recommend using the lowest layer height available for your printer
Installation
The feet are installed directly in place of the original rubber feet:
Remove the original rubber feet from the keyboard. This will reveal the screws underneath.
Remove the original screws.
Replace the original feet with the printed riser feet.
Secure them using:
2 × M2 × 8 mm screws for the two taller/rear feet
2 × M2 × 5 mm screws for the two shorter/front feetThe original rubber pieces can optionally be placed back on top of the new raised feet.
No permanent modification to the keyboard is required.
Features
Designed specifically for the Logitech Pebble 2 K380s
Set of 4 keyboard riser feet
Raises the keyboard for a more comfortable typing angle
Uses the keyboard's existing screw mounting points
Original rubber feet can be reused
Hardware required:
2 × M2 × 8 mm screws
2 × M2 × 5 mm screws