1 / 2
Riser for Ratgdo Encoder — image 1
1 / 2

Riser for Ratgdo Encoder

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Riser for installing a Ratgdo Encoder on garage door openers that have a plastic guide blocking the gear

Rating
0 / 5
Likes
0
Downloads
1
Makes
0
Views
21
Reviews
0

Updated at source:

Model information

License
Creative Commons — Attribution — Noncommercial

I purchased a Ratgdo Encoder to install on my Craftsman garage door opener, so that I can use the Ratgdo in "Dry Contact" mode. However, my opener has a plastic chain guide covering a portion of the gear, which would prevent the magnetic arm from being installed directly on top of the gear like Ratgdo's documentation suggests, so I made this riser to lift both the magnetic arm and the encoder high enough to clear the guide.

Both risers are designed to have a standard sized disc magnet installed in the base to allow them attach to the top of the opener. The encoder riser should have an M6x18 metal washer in the top, while the magnet riser should have a M5 nut installed with the flat side up. These will allow the encoder and magnetic arm to attach to the risers. The magnets and washer should be glued/taped in place, but the nut doesn't necessarily need to be.

Parts required:

  • 2x Ceramic Disc Magnets (.75" x .75" x .2")

  • 1x M6 x 18 washer (not stainless steel)

  • 1x M5 nut (not stainless steel)

  • Glue or double-sided tape

Example images were printed with PCTG filament, oriented vertically, with tree supports.

As always, the garage door opener should be powered off when working on it to avoid potential injuries. Additionally, be sure to check clearances when installing to make sure that the risers don't rub against the chain or guide, as that may knock it out of alignment and/or risk rubbing off into the chain.

Tags