1 / 6
Uni-t UTi690A / UTi120s / UTi712s lens cover / 20 mm macro lens combo — image 1
1 / 6

Uni-t UTi690A / UTi120s / UTi712s lens cover / 20 mm macro lens combo

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Here is my take on a lens cover / 20 mm ZnSe macro lens combination to be used with Uni-t UTi690A (tested) / UTi120s -…

Rating
0 / 5
Likes
2
Downloads
54
Makes
0
Views
597
Reviews
0

Updated at source:

Model information

Category
Other Ideas
License
Creative Commons — Attribution

Here is my take on a lens cover / 20 mm ZnSe macro lens combination to be used with Uni-t UTi690A (tested) / UTi120s - UTi712s (it should work as they seem to pretty much be the same camera) thermal cameras that does not require glue or magnets and can be printed entirely in PLA.

Print flat side down, no support needed; about 2h print on an Ender 3.

Print Settings

Printer Brand:

Creality

Printer:

Ender 3

Rafts:

No

Supports:

No

Resolution:

0.25

Infill:

20%

Filament: Generic PLA Black


Notes:

After printing, you might need to trim a little bit the hinge part to ensure that cover and cap fit without much slop.
Once the two parts fit together and are aligned, use a small piece of filament inserted into the hinge holes to act as the hinge itself. It should be a fairly tight fit. The filament should then be trimmed to stick from the hinge by 3 to 5 mm on each side, so that then it can be melted with a soldering iron to fix it in place permanently. I used white filament to highlight what it should look like at the end (second picture).

The 20 mm ZnSe lens needs to be inserted into the 20mm ring (again, it should be a tight fit) and finally the lens+ring assembly should fit tightly into the corresponding hole on the lens cover. The ring should insert until it is roughly flush to the back surface, as shown in the third picture.

A bit of trimming might be required, depending on how good are your printer tolerances.

Category: Parts

Tags