MPC Tilt Screen with Screen Protector

Description
This mod allows you to have a tilted screen on your MPC with a screen protector. If you are like me, you throw your MPC in your bag on the go. The Screen protector slides on and locks in place to keep your screen from getting damaged, now that it is sticking out of your device.

3MF Notes:
The AMS file uses ABS with PETG as a support interface. This file requires an AMS.
The NOAMS file uses standard support settings, and does not require an AMS.

Parts Needed:
uxcell 0.5mm Pitch 8 Pin to 8 Pin Extension Connector Adapter for FFC FPC - https://www.amazon.com/dp/B07RT6XHHW?ref=ppx_yo2ov_dt_b_fed_asin_title

Flexible Flat Cable 8 Pins 0.5mm Pitch 100mm A Type -https://www.amazon.com/dp/B0F4HXPC82?ref=ppx_yo2ov_dt_b_fed_asin_title&th=1

Assembly:
Remove screws from bottom, notating where each screw goes.
Remove screws from the rear, notating where each screw goes.
Remove ¼” retainers with a 14MM socket.
Once opened, remove two screws holding in the SOC.
Carefully tilt the SOC, then disconnect all cables except the antenna (MPC One+ and G2).
Remove tape holding wide ribbon cable for the screen.
Disconnect the 8 pin ribbon cable for the screen.
Ensure the screen is supported in the front.
Remove the screws holding in the screen.
Carefully slide the screen out, ensuring it comes out evenly (DO NOT TILT).

Set the MPC right side up.
Insert the screen into the tilt bezel.
Use 2 of the silver screws, that were previously holding in the screen, to secure the screen to the bezel.
Attach the Extension Connector to the small 8 pin ribbon cable.
Attach the 31 pin ribbon cable to the screen.
Slide the adapter into the open slot on the left side of the monitor location.
While gently sliding the ribbon cables into the device, set the bezel into place.

Flip over the MPC.
Slowly screw screws in to mounting bezel, applying slight pressure.
Attach one end of 8-pin cable to the Extension Connector.
Attach the other end to the PCB.
Re-attach cables to the SOC.
Tape down ribbon cable, as it was previously.
Attach SOC, and re-insert screws being careful not to cross-thread or strip existing threads.
Perform a power on test of the MPC.
Attach power cable, then power the device on.
Ensure touchscreen powers on and responds to touch.
Immediately power the device back off, and detach power cable.

Re-attach bottom plate.
Attach ¼” retainers using a 14MM socket. DO NOT OVER-TIGHTEN.
Re-insert all screws being careful not to cross-thread or strip existing threads.
Plug the device back in.
Power it on.
Have fun!

Known Compatible Models:
Akai MPC One G2
Akai MPC One Plus
Akai MPC One
Akai Force

Possible Compatible Models:
MPC Live III
MPC Live II
MPC Live

Version History:
V1.0 - 2026-10-09 - Initial release. 12.5 Degree File attached.


Future Versions:
V2.0 - Additional angles will be added including 20, 30, 40, and 45 degrees.