1 / 2
IKEA Jansjö clamps without the need for v1431 pads — image 1
1 / 2

IKEA Jansjö clamps without the need for v1431 pads

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

If you don't have the v1431 pads, the surface of the pad holders is flattened, so you can glue your own rubber pads on.

Rating
0 / 5
Likes
2
Downloads
4
Makes
0
Views
15
Reviews
0

Updated at source:

Model information

License
Creative Commons — Attribution — Noncommercial — Share Alike

Just like Q I would suggest printing PETG. PLA will become too brittle over time. The hinges might break of due to the strong spring in the clamp.

I used an infill of 25%. But I set the wall count to 5, so the hinge brackets are printed solid. These settings saves about 40% material, while the hinges are still strong.

By accident I stumbled upon some foam rubber pad which I cut in half and fitted perfect (see photo). If you don't have such foam rubber pad, I would suggest a piece of rubber of an inner tube of a bicycle. If you don't have an old inner tube, just go to your local bicycle store and ask for an old broken tube.

I didn't have a long M3x40mm screw, so I used 2 smaller ones (I think M3x15mm). They fit so tight (also because of the strong spring), that I didn't attach a nut to them. If you don't open the clamp on a daily basis, you don't have to worry the screws will fall out.

Tags