1 / 2
Lever action bow cam driven Ripcord Drive drop away arrow rest. — image 1
1 / 2

Lever action bow cam driven Ripcord Drive drop away arrow rest.

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Conversion for Ripcord Drive drop away arrow rest to be driven by the cams of a lever action bow instead of string/limbs

Rating
0 / 5
Likes
0
Downloads
1
Makes
0
Views
38
Reviews
0

Updated at source:

Model information

Category
Other Sports
License
Creative Commons — Attribution

Mod I made to allow a drop away arrow rest to be cam driven on certain lever action bows. This cleans it up and doesn't require the rest to have a cable strung across to either the bowstring or down/up to a lever. 

BOM

vinyl coated steel cable, 3/32 OD - https://a.co/d/0gJA8U1h 
lubricant - lithium grease, though a dry carbon lubricant or bearing grease might also work
1x button head screw, exact size might differ depending on clearance on the riser. 
1x insert screw, size might differ depending on the riser mount, or mount might not have it at all. If no screw exists, then double sided tape can work in place, screw is only meant to keep the deflector in place and against the mount. 
2x crimping sleeves, the amazon link currently comes with the ones you'd need
heat shrink to cover the sleeves after crimping to prevent rubbing and to give a more finished aesthetic. 

Tools:

Crimper 
heat gun/lighter

Crimp both ends of the cable into a loop, and attached one to one of the cam draw stops, the other attached to the drop away rest, screwed in where the connection to the limbs or the string would go. I crimped one end, fed the cable along the path through the grip channel, around the mounted deflector, across the upper wheel and to the cam, measured it out and crimped the other side. You want it to be under a good amount of tension so you get consistent results when firing. 

The upper wheels file is just attached above the mounting screw for the vertical adjustment on the rest, the deflector is attached over the actual bow mount that screws to the riser. That is held more in place with a simple insert screw. I lubricated the inner channel of the grip so that the cables didn't wear much on one another or against the riser. That was lubricated initially with lithium grease, but could likely be done with something else. It worked, so I never bothered switching it to anything else like a dry lubricant or bearing grease.

All prints were printed in PETG and work for quite a while. Nylon and PPS might be a better fit, lasting longer before needing reprinted, but I have not tested the model with them. 

Tags