iPhoneX Motorcycle Bracket
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Slide in bracket to hold the iPhoneX that I use on my motorcycle.
- Rating
- 0 / 5
- Likes
- 5
- Downloads
- 32
- Makes
- 0
- Views
- 551
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Portable Devices
- License
- Creative Commons — Public Domain
Slide in bracket to hold the iPhoneX that I use on my motorcycle. Requires a mounting device like the Wunderlich MultiPod or RAM mount, 2 screws and nuts. I am new to 3D printing so if you have improvement suggestions or comments let me know. I might also be willing to modify this design to different needs.
Print instructions
Slic3r 1.41.3. Settings
0.10mm Detail
PETG
40% Fill Density (seems to be plenty strong)
Supports YES everywhere
Brim YES (but probably could do without)
Support Changes to Defaults:
Overhand Threshold: 70% (Maybe adjust higher to improve cleanup?)
Contact Z: 2mm
Pattern: Honeycomb
Spacing: 3mm
Interface Layers: 1 (I read somewhere that this would be easier to remove than 2 layers, but it was still difficult to remove)
Interface patterns spacing: 0.3mm
Don’t support bridges: Turn This OFF! (i.e. NO checkmark. If you leave this on the back side will be a stringy mess)
The cleanup takes some time and a very sharp knife to remove supports that are inside the bracket. Takes about 9 hours to print.