1 / 3
Starlink Mini Flat Magnetic Roof Mount Aerodynamic — image 1
1 / 3

Starlink Mini Flat Magnetic Roof Mount Aerodynamic

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Sleek, Aerodynamic Magnetic Roof Mount for Starlink MiniUpgrade your mobile internet setup with this extremely low-…

Rating
0 / 5
Likes
3
Downloads
24
Makes
0
Views
106
Reviews
0

Updated at source:

Model information

Category
Electronics
License
Creative Commons — Attribution — Share Alike

Sleek, Aerodynamic Magnetic Roof Mount for Starlink Mini

Upgrade your mobile internet setup with this extremely low-profile and aerodynamic roof mount. Perfect for vanlife, RVs, or overlanders. This mount allows you to securely attach your Starlink Mini flat to your car's roof using rubberized magnetic feet.

Design & Assembly Instructions:

To make printing easier and more accessible on standard print beds, the main housing design is split into four quarters that you will pair, glue, and then connect to form a two-part enclosure for your Starlink Mini.

The Print: Print the 4 main housing quarters. Print the 4 connector pins.

Assemble the Two Halves (Pairing & Gluing): Take the quarters and permanently glue them together in pairs (front+back for the left side, and front+back for the right side) using a strong 2-component (2K) epoxy/adhesive. You will now have exactly two side halves (a left side half and a right side half).

Install the Connector Pins: Glue the 4 small connector pins into the designated holes of one of the assembled side halves using your 2K adhesive, pushing them in completely. Let the glue cure fully.

Insert the Dish: Place your Starlink Mini into the side half with the pins.

Slide Together & Secure: Slide the second side housing half over the protruding pins. The pins will perfectly align and center the two halves around the device. Screw the flat magnetic mounts to the bottom. The bolted connection of the magnetic feet acts as the final lock, clamping the entire assembly securely together. Required Hardware:

4x Flat, rubberized mounting magnets (Diameter: 66mm, Thread: M6, 30kg) 2-Component (2K) epoxy adhesive (for assembling the housing quarters and the connector pins) Appropriate screws/bolts for the magnets (normally included with the magnets) Print Settings:

Material: ASA, ABS, or PETG highly recommended (PLA is not suitable due to UV exposure and high roof temperatures in the summer). Infill: 25-30% Gyroid for optimal strength. Walls: 4-5 walls (perimeters) for extra durability.

⚠ RISK DISCLAIMER ⚠

The manufacturing and use of this mount are strictly at your own risk! The creator of this 3D model assumes no liability for direct or indirect damage to the vehicle, the Starlink device, persons, or third parties caused by the use or detachment of the mount while driving.

Please test the holding force of the magnets on your specific vehicle roof before your first drive. The vehicle roof must be absolutely clean, dry, and free of grease before attaching the magnets. For driving at higher speeds (especially on highways), an additional mechanical safety tether is strongly recommended!

Category: Electronics

Tags