Rivian R1S (Gen1) Print In Place Front License Plate Holder
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Front License Plate Holder for Rivian R1S (1st Gen) and R1T. Print-in-place. With security hole for hex nut.
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 1
- Makes
- 0
- Views
- 21
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Automotive
- License
- Creative Commons — Attribution
R1S Print-in-Place Front Plate Holder
A PETG front license plate holder designed for a 2023 Rivian R1S and a standard 12 × 6 in California plate. The sloped hood positions the plate forward of the recessed grille while maintaining a clean front profile.
A print-in-place cassette contains the sliding actuator, rack, gears, and three rotating latch shafts. Pressing the actuator moves all three latches together through 90° to secure the holder in the grille. The front hood and plate backing snap together to create the finished plate frame.
Three separate pill-shaped PETG latch pieces attach to the rotating shafts with centered M3 × 35 screws and captive M3 hex nuts. Each latch prints flat without supports. Use a 1.20 mm metal M3 washer/spacer stack between each shaft and latch.
Print files
02_front_hood.stl — Sloped front hood and upper plate-frame section
03_plate_backing.stl — Plate backing and lower frame section
07_bolted_pip_cassette.stl — Print-in-place actuator cassette
08_bolted_pill_latches.stl — Three separate flat latch pills
09_bolted_latch_coupon.stl — Hardware and grille-fit test coupon
Print and assembly
Print in PETG. Print the cassette, latch pills, and coupon without supports; use the supplied orientations for the hood and backing. Start with the coupon to confirm M3 nut fit, screw clearance, latch rotation, and grille engagement.
Press one M3 hex nut into each rotor pocket. Place a 1.20 mm metal M3 washer/spacer stack over each shaft, then secure each pill latch with an M3 × 35 screw. Tighten only until seated.
Snap the hood onto the cassette, then snap the plate backing into the hood. The clips provide the primary mechanical retention; PETG-compatible glue may be added to the reinforcement rail after fitment is confirmed.
