Mini SVS Evolution Bookshelf Speakers

These are Mini SVS Evolution bookshelf speakers, (they pair great with my Mini SVS PB-17 Ultra!). The videos filmed with my phone don't do the audio justice, these sound really good, crisp highs, the bass is punchy and warm, they don't go super low but they really aren't designed for that at this size. 

 NOTE: these are a little difficult to print, I've done a lot of work to get them to finally print properly and you shouldn't have an issue, but the combination of curves and angles of these boxes makes it hard to print well, I ended up adding sprews (modeled removable supports) to make it stable and print at a 45deg angle. You will also need a .2 nozzle to print the fake tweeter and SVS logo (they have tiny details). Just keep an eye on it while it prints to ensure there are no issues. 

 Here is my mini SVS PB-17 Ultra subwoofer if you want to print it as well!

https://www.printables.com/model/1786775-mini-svs-pb-17-ultra-subwoofer

Speakers: (2) Dayton Audio PC68-4 2-1/2" Full-Range

Amp: Amplifier: ZK-MT21 2.1 Channel Bluetooth Amplifier Board – Mini

HARDWARE: 

(20) M3 x6mm cap head self tapping screws (Enough for two speaker boxes)

(2) 2.2 Inch Square banana plug speaker spring terminals

(16) 6x4mm round magnets (only needed if using the speaker grills)

(Optional) fiberfil (cotton, like you fill pillows with) to stuff the inside of the speaker box (it helps speaker boxes sound better with deeper bass)

PRINT SETTINGS:

Any hard filament for box, SVS bandge, tweeter and grill 

 Smooth plate or glue stick recommended for extra adhesion when printing the box

 TPU for gaskets and speaker feet

 Printing the box slower than normal recommended since these are printed at a 45deg angle

 .2 Nossle necessary for printing the fake tweeter, it has very tiny grill details that won't print with a .4

 .2 Nossle recommended for svs badge (but yuo can probably get away with a .4 if need be)

Assembly:

Insert (4) 6x3 or 6x4mm magnets (either will work) into the hidden magnet spots behind the speaker box face (put your fingers through the speaker opening and feel with your hand to find them, use the speaker grill you printed for reference where they should be on the box. If you have any trouble inserting the magnets you can also use 5mm round magnets and glue so they fit more easily. 

 Wire up your speaker

Put TPU gaskets on the terminals before screwing them in with M3 x 6mm screws

Press in speaker beauty ring

Screw in the TPU speaker feet to the bottom of the box

 For the speaker grill, to finish it like I show in the pictures you use 3m spray glue to attach stretchy speaker grill cloth (you can get it on amazon etc), then just use a razor knife to cut excess from the back side of the grill. Finally glue in the 6x4mm magnets in the spots modeled for them on the back side.

For the SVS logo, you can leave it raw or cover it in clear epoxy resin to make it look like mine 

If you would like to leave a tip for my hard work you can do so here :D https://www.paypal.com/ncp/payment/Y5DRF7PN8S5AJ