Top Prime Mini Talon Claw U
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Chonky boiiii
- Rating
- 0 / 5
- Likes
- 8
- Downloads
- 10
- Makes
- 0
- Views
- 100
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Outdoor Toys
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Top primed mini less hardware talon claw. Still requires a fair number of screws, aluminum flat bars, and a threaded rod for the body.
Can hit 90 - 220 fps depending on barrel length and spring. Shown with ~3 inch barrel and 22 inch barrel.
Hardware -
3m screws
4x 4mm
12x 10mm
6-8x 20mm
1x 40mm (optional for rear plunger housing, could sub for 2x 10mm)
2x extension spring (sear and mag release) or equivalent elastic
2x 45mm m5 /10-32 / 10-24 sized screws + 2x nuts
240mm threaded rod (10-32 / 10-24) + 2x nuts
o-rings
3x -123 for plunger seal (https://www.mcmaster.com/9452K87/)
1-2x -012 for pusher seal (https://www.mcmaster.com/9452K21/)
plunger tube - ~108mm long standard slug size (https://www.mcmaster.com/8585K207/)
2x aluminum flat bar - 15.75mm long, no thicker than 3.2mm
note - will require tapping (3m) screw holes because there's no room for retention nuts on the interior
Optional - printed barrel, plunger tube, ect from SillyButt's low hardware talon claw - https://www.printables.com/model/876167-low-hardware-talon-claw-u-lhtcu