1 / 2
Arduino VENTUNO Q — Enclosure with Integrated LED Light Guides — image 1
1 / 2

Arduino VENTUNO Q — Enclosure with Integrated LED Light Guides

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

A remix of the original Arduino VENTUNO Q enclosure, bringing the board’s status LEDs to the front.

Rating
0 / 5
Likes
2
Downloads
24
Makes
0
Views
124
Reviews
0

Updated at source:

Model information

Category
Electronics
License
Creative Commons — Attribution — Share Alike

This version retains the original front-cover outline and adds a window over the LED matrix, screw-mounted acrylic retaining clips, and front access to the board’s side button.

Choose your version

  • With case: front panel and enclosure walls printed as one piece.

  • Front only: replacement front panel with integrated light-guide channels, for use with an existing enclosure.

Important — modification required for the front-only version:
Remove a small 22 × 15 mm section from the existing enclosure wall where the enclosure narrows, to provide clearance for the light-guide channel. Check the channel position against your enclosure and mark the area before cutting. Remove the electronics before modifying the enclosure.

This separate clearance cut is not required when printing the integrated-case version.

Integrated LED diffusers

Print the front face against the build plate. Start with transparent filament for one 0.25 layer, then change to the enclosure colour above the thin membranes closing the LED openings.

Use the same filament material for both colours. My rack version uses transparent PETG followed by coloured PETG.

Match the first-layer height and filament-change height to the diffuser membranes, and check the sliced preview before printing. The transparent sections should remain transparent through their full thickness.

If a transparent first layer is not practical, carefully open the front membranes and insert transparent filament into the light-guide channels. I use 1.75 mm transparent PETG filament. Secure it without pressing against the LEDs.

The printed-in transparent membranes are my preferred method for a clean, flush finish.

Acrylic window

  • Window pocket: 43 × 63 mm

  • Visible opening: 39 × 59 mm

  • Suggested acrylic cut size: 42.5 × 62.5 mm

  • Intended acrylic thickness: 3 mm

Check the fit and lightly sand the edges if needed.

Print four window-retaining clips and screw them onto the rear of the front panel. Different acrylic thicknesses can be accommodated with suitable screw lengths and secure clip engagement. Tighten gently.

Fit and testing

These variants were derived from my printed and installed 3U rack version by trimming the models to the original front-cover outline. The exported meshes have been checked, but these exact standalone variants have not yet been physically test-fitted.

The original rear cover is not included. On my assembly, several underside components contacted that cover, requiring additional clearance openings. Check the rear-cover fit before tightening it onto the board.

Related rack version

For a 10-inch rack, the 3U version is available here:

Tags