1 / 1
Piranha Plant Valve Index Controller Stand
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Remix of the Piranha Plant to hold your Valve Knuckles. No MMU/AMS needed.
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 3
- Makes
- 0
- Views
- 29
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Virtual Reality
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Print Instructions:
15% infill
Supports: Yes
0.2 Layer Height
I recommend adding a brim for the head and teeth.
Assembly Instructions:
Check out the original post for gluing instructions.
It was a bit hard to figure out where the spots go from the original model, but I found that just brute forcing them into place wasn't the worst. Good luck!
If you'd like to make a remix, here is the OnShape link.