1 / 4
Customizable Gear Ratio 1:2:3 Hand-Crank Souvenir (12T/24T/36T) - Untested Design — image 1
1 / 4

Customizable Gear Ratio 1:2:3 Hand-Crank Souvenir (12T/24T/36T) - Untested Design

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Three-gear 1:2:3 ratio souvenir with hand crank. Untested native Playground design. Recipe and guide included.

Rating
0 / 5
Likes
0
Downloads
1
Makes
0
Views
11
Reviews
0

Updated at source:

Model information

License
Creative Commons — Attribution

This is an untested design, not a proven print. Fit, clearances, tolerances and print behaviour have not been checked on a real printer, and nothing here promises that printed parts turn freely. Test a small print first.

A three-gear chain souvenir showing a 1:2:3 gear ratio (12T/24T/36T spur gears, module 2, 8 mm wide). Each gear sits on its own shaft in a back plate and plinth, with a red crank pin on the first gear. Each gear in the chain is 12 teeth bigger than the one before it, 12T then 24T then 36T. For one crank turn the middle gear turns half a turn and the last gear turns one third of a turn. For a full lap of all three you need 3 crank turns.

How it turns: gears have a 3.0 mm bore radius on 2.8 mm radius shafts, about 0.2 mm radial clearance, and a thin disc on each shaft end keeps the gear on. Teeth mesh at a centre distance equal to the sum of the tooth counts (module 2). The Playground mesh command has no clearance or backlash setting, so teeth clearance could not be tuned. If teeth bind, increase the centre distance a little.

This is a customizable model. Change the tooth counts and colours in the attached Playground recipe and run it in the TrueGeometry Playground (the attached guide shows how). Full commands and design notes: https://blog.truegeometry.com/0_0_0_0/blogs/post-93f5c27f.html

STL notes: the main file is a full-assembly STL in upright Z-up orientation (188 x 56 x 108 mm, 11572 triangles), extracted from the native Playground scene with no repair and no union. It is a display snapshot, not a print-in-place mechanism. Shafts pass into the back plate as overlapping shells with no socket modelled, the crank pin overlaps the first gear, and the native mesh has 280 zero-area triangles. These are kept as they are, not repaired. No slicer or physical print test was done.

Not a toy for young children (small parts). Built with AI assistance in the TrueGeometry Playground.

Blog

Playground

Tags