1 / 5
Heron's fountain - Roman style — image 1
1 / 5

Heron's fountain - Roman style

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Working Heron’s fountain in one support-free PLA print, no glue or seals, dressed as a two-story Roman arcade.

Rating
0 / 5
Likes
0
Downloads
6
Makes
0
Views
22
Reviews
0

Updated at source:

Model information

License
Creative Commons — Attribution — Noncommercial

A 2,000-year-old fountain design you can print in one piece.

Heron of Alexandria described this fountain in the 1st century AD: pour water into the basin, and a jet rises from the center, seemingly driven by nothing. The trick is air pressure. Water falling from the basin into the lower chamber compresses the air there, which is piped to the middle chamber and pushes its water up through the nozzle.

The smaller fountain in the video (long tip) is 100%; the larger fountain (small tip) is printed at 110%. 

What makes this version different

  • One single print. No gluing, no tubes, no seals, so no leaky joints.

  • No supports. All internal ceilings are 45° funnels around a central column, and every internal passage has a pointed roof.

  • Hidden plumbing. The air channel runs inside one of the pilasters, so nothing breaks the facade.

  • Roman edition. 

Print settings (PLA)

  • 0.2 mm layers (0.12–0.16 mm for crisper lettering)

  • 4+ walls, 20–25% infill (watertightness comes from the walls), more walls better airtightness.

  • To improve airtightness, you can increase flow to 102–105%, and make nozzle about 5 °C hotter than usual for better layer bonding

  • No supports needed

If the jet is weak, the print is probably leaking air. A thin coat of epoxy on the outside should fix it.

How to start it (100% size)

  1. Pour about 150 ml of water into the basin; it drains into the lower chamber.

  2. Turn the fountain upside down with the back pillar facing down and tilt it well. The water moves through the hidden air channel into the middle chamber.

  3. Turn it upright with the back pilaster facing up, so the water stays in the middle chamber.

  4. Pour water into the basin, and the fountain starts.

How to empty it
Do the flip from step 2, turn it upright, then press a syringe full of air (with a short piece of silicone tube on the tip) into the drain hole in the basin floor and push. The water comes out through the nozzle. Repeat until only air comes out. You can use distilled water to avoid mineral rings and algae.

Notes

  • A lower nozzle tip gives a taller visible jet and a longer run.

Tags