Bed and Y Stabilizer 2
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This thing was made with Tinkercad. Edit it online https://www.tinkercad.com/things/7t0VmBQPj1k This is my 2nd version…
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 6
- Makes
- 0
- Views
- 97
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Ideas
- License
- Creative Commons — Attribution — Share Alike
This thing was made with Tinkercad. Edit it online https://www.tinkercad.com/things/7t0VmBQPj1k
This is my 2nd version of a bed stabilizer. the tiny hole in the middle is for a small nail that locks spring in place. Bearing holders came from Adonirams design I found on Thingiverse you need 2 of them . You will also need 2 5mm x 11mm 2 mm bearings. ( I got from BocaBearing.com).
Instructions
print 2 bearing holders 1 Y stabilizer cut 2 pieces of .175 ( 3/16 inch) thick steel rods (got at local hobby shop) approximately 5.25 inches long. Then cut a compression spring (from local hardware store) approximately 1.75 inches long . Set spring in middle of Y stabilizer and push small nail thru hole . add bearings to each side and install in center of bed bottom rail . I ground end of steel rods for a tight fit.
Category: 3D Printing