1 / 7
Elegoo Saturn 4 Ultra 16K – 90° Vent Hose Adapter (100 mm) — image 1
1 / 7

Elegoo Saturn 4 Ultra 16K – 90° Vent Hose Adapter (100 mm)

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Right-facing 90° vent adapter for the Saturn 4 Ultra 16K, with a 70 mm inlet and 100 mm OD hose connection.

Rating
0 / 5
Likes
3
Downloads
25
Makes
0
Views
87
Reviews
0

Updated at source:

Model information

Category
Accessories
License
Creative Commons — Attribution — Share Alike

A compact, right-facing vent hose adapter designed around the rear vent measurements of my Elegoo Saturn 4 Ultra 16K.

I designed this to connect the printer’s 70 mm rear opening to a hose using a 100 mm outside-diameter spigot, with only 110 mm between the printer and the wall. The adapter turns 90° before expanding, allowing the hose to run parallel to the printer’s back.

Features

  • Outlet points right when viewed from behind the printer.

  • 80 × 80 mm mounting plate, 5 mm thick.

  • Four 3.4 mm clearance holes on a 64 × 64 mm mounting pattern.

  • 70 mm inlet and elbow bore.

  • Reinforced 5 mm elbow wall and rounded mounting-root reinforcement.

  • 100 mm outside-diameter hose spigot with a 4 mm wall.

  • 50 mm straight hose engagement.

  • Overall dimensions: approximately 180 mm wide × 105 mm deep × 100 mm high.

Hardware and installation

Use four suitably sized M3 screws and nuts, a compatible hose, and a standard band clamp. Screw length depends on your installation.

Move the printer away from the wall to attach the hose. Position the clamp’s screw housing above or below the connection to preserve rear clearance.

The adapter itself projects 105 mm behind the printer. Allow additional clearance for the hose and clamp. Check the listed mounting dimensions against your printer; compatibility with other Saturn models has not been confirmed.

Print and testing status

Revision 00 is a prototype. The CAD solid and exported mesh have been checked, but a successful print and installation have not yet been recorded. Print orientation, supports, material settings, and physical fit remain to be validated.

Files and feedback

STL, STEP, and editable FreeCAD files are included. Designed in FreeCAD with AI assistance.

Feedback, makes, and remixes are welcome—especially installation photos and notes about hardware, hose fit, and print settings.

Tags