1 / 4
SKÅDIS Spice Shelf - Tilted, with a Label Rail - No Supports (SlideLock clips) — image 1
1 / 4

SKÅDIS Spice Shelf - Tilted, with a Label Rail - No Supports (SlideLock clips)

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

A tilted spice jar shelf for IKEA SKÅDIS with a label rail. The hooks are clips that print flat: no supports.

Rating
0 / 5
Likes
3
Downloads
7
Makes
0
Views
40
Reviews
0

Updated at source:

Model information

Category
Kitchen
License
Creative Commons — Attribution — Noncommercial — Share Alike

A spice shelf for the IKEA SKÅDIS pegboard. It holds three jars up to 48 mm across. The floor tilts back 6 degrees, so the jars lean against the wall instead of drifting to the edge, and the front rail has a channel for a paper or tape label strip.

SLIDELOCK: HOOKS THAT PRINT WITHOUT SUPPORTS

Pegboard parts with hooks usually need supports under the hook tails. This one doesn't: the hooks are two separate SlideLock clips that print lying flat, so their layers run along the hook, the strongest way to print a hook. The shelf prints upright on its flat bottom. Nothing on the plate needs a single support.

• The organizer rests on the top of each clip, so the clips carry the weight in compression.

• Each clip's leg sits in a channel behind a 4.8 mm slit it can't pass through, so the shelf can't be pulled off the clips.

• A spring finger on each clip clicks into a pocket, so the clips stay in the shelf when you lift it off the board.

ASSEMBLY (1 minute)

  1. Push a clip's leg into the window at the bottom of a slot on the back of the shelf.

  2. 2. Slide the clip up until it clicks. Do the same with the second clip.

  3. 3. Hang the shelf like any SKÅDIS accessory: hooks into two slots of one row (120 mm apart), push in, let it drop.

  4. To take it down, lift it up and out. To take a clip out of the shelf, pull it down firmly (the click bump has 45-degree ramps), then take it out through the window.

  5. PRINTING

  6. • Shelf: upright on its flat bottom. Clips: flat, as in the files. No supports, no brim.

  7. • PLA or PETG, 0.2 mm layers, 3 walls, 15% infill.

  8. • Bambu Studio (H2C, everything on one plate): 2 h 31 min, 86 g. The included 3MF is set up and sliced clean.

  9. CUSTOMIZE (OpenSCAD Customizer)

  10. Width in SKÅDIS columns (2 to 6), jar depth, rail height, tilt, label channel on or off. Keep slidelock.scad next to the .scad file.

  11. Part of a set of five SlideLock organizers: spice shelf, coffee capsule dispenser, self-watering herb planter, dog walk station and thread rack. The clips are the same for all of them.

Tags