1 / 4
SKÅDIS Self-Watering Herb Planter - Water Reservoir and Wick - No Supports (SlideLock clips) — image 1
1 / 4

SKÅDIS Self-Watering Herb Planter - Water Reservoir and Wick - No Supports (SlideLock clips)

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Self-watering herb planter for IKEA SKÅDIS: water reservoir, wick basket and a filling chute. No supports.

Rating
0 / 5
Likes
3
Downloads
9
Makes
0
Views
69
Reviews
0

Updated at source:

Model information

License
Creative Commons — Attribution — Noncommercial — Share Alike

A self-watering herb planter that hangs on the IKEA SKÅDIS pegboard, for basil, mint or parsley by the kitchen window.

HOW IT WORKS

• The outer pot is the water reservoir and hangs on the board.

• The inner pot holds the soil. Its floor is a funnel that ends in a slotted wick basket standing in the water, so the soil in the basket draws water up as the plant needs it.

• Top up through the chute in the front corner: it runs through the soil straight into the reservoir.

• The inner pot stands on the reservoir floor on the wick basket, the chute and three feet, so you can lift it out to clean or repot.

SLIDELOCK: HOOKS THAT PRINT WITHOUT SUPPORTS

The hooks are two separate SlideLock clips that print lying flat (layers along the hook, the strongest way to print one), and they sit in the back plate above the rim, away from the water. Both pots print upright with no supports: the funnel floor is 45 degrees or steeper all round.

• The planter rests on the top of each clip, so the clips carry the weight in compression.

• Each clip's leg sits behind a 4.8 mm slit it can't pass through, and a spring finger clicks it in place.

ASSEMBLY

  1. Push a clip's leg into the window at the bottom of a slot on the back plate, slide it up until it clicks. Same for the second clip.

  2. 2. Hang the outer pot on SKÅDIS: hooks into two slots of one row (80 mm apart), push in, let it drop.

  3. 3. Fill the wick basket and the inner pot with potting soil, plant, and set it in. Water from the top the first time, then through the chute.

  4. PRINTING

  5. • Outer pot upright in PETG (for water), 4 walls, 0.2 mm layers. Inner pot upright, PLA or PETG. Clips flat. No supports.

  6. • Bambu Studio (H2C, one plate with everything): 7 h 23 min, 258 g. The included 3MF is set up and sliced clean.

  7. CUSTOMIZE (OpenSCAD Customizer)

  8. Width (3 to 5 SKÅDIS columns), depth and height. Keep slidelock.scad next to the .scad file.

  9. Part of a set of five SlideLock organizers: spice shelf, coffee capsule dispenser, self-watering herb planter, dog walk station and thread rack. The clips are the same for all of them.

Tags