DJI Mavic 2, 8" Tablet Mount
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A Tablet mount to enable an 8" tablet to be used as the controller display for a DJI Mavic 2 Pro instead of a phone.
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 4
- Makes
- 0
- Views
- 34
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- RC & Robotics
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
DJI Mavic 2 Tablet Mount
A Tablet mount to enable an 8" tablet to be used as the controller display for a DJI Mavic 2 Pro instead of a smart phone.
Print Settings
Print Details
Bambu Lab P1S Printer
Rafts: Yes
Supports: Yes
Resolution: 0.2
Infill: 30%
Filament material: PLA
Filament brand:
Bambu PLA Basic
Filament colour: Any
Notes:
The rafts are optional for some parts such as the latches and as usual, a small amount of cleaning up may be necessary.
The example shown has a cable tidy but this was found to be unnecessary. also the lower part of the tablet holder is more compact than depicted.
Post-Printing
The following are needed to complete the assembly:-
6 pieces of 2mm piano wire 10mm long
4, 3mm x 16 countersunk woodscrews
2, 3.18mm OD Tension Springs 0.5 wire dia carbon steel R1.77 x 14mm long with looped ends obtainable from "Springs and Things". https://springsandthings.me.uk/
The two sprung latches each use 2, 10mm long pieces of 2mm piano wire to anchor the springs and one each as the pivot.
The top and bottom decks are fastened together using the wood screws and the piano wire can be cut to length with a Dremel.
How(why?) I Designed This
I designed this mount as I felt the need for a bigger display to control the Mavic 2 Pro without having to pay for a DJI Smart Controller, I also wanted to avoid getting phone calls during a flight. (This has actually happened!)
The console uses a standard 8” tablet and has a pocket to accept a power pack.
I used a Samsung TAB ASM SM-T220 tablet which fitted perfectly and an X-Dragon 500,000Mah battery pack , model XD-SC-012-E purchased from ebay.
If a different 8" Tablet is used, you will need to ensure that the mounting claws do not interfere with the buttons.
The tablet mounts very quickly and is securely held in place.
The assembly mounts on the controller in the same way as a phone and when used with a neck strap also balances quite nicely.
A light neck strap can be held by two small eyelets which are screwed into the 2.3 dia hole in the side lugs.
With suitable leads, the power pack can be used to power the controller giving it far greater capacity.
Everything was printed in PLA with 30% infill and I had no problems with strength.
One off each ; Tablet mount upper.stl, Tablet mount lower.stl
Two off each; Tablet mount latch.stl
