Witch's Cauldron Treat Bowl — boiled-over rim, no supports
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A cauldron for the sweets by the door.
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 0
- Makes
- 0
- Views
- 1
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Autumn & Halloween
- License
- Creative Commons — Attribution — Noncommercial
A cauldron for the sweets by the door. Belly, pulled-in neck, rolled lip, and a rim that dips and rises as though something inside it had boiled over. It holds a good two bags of fun-size bars.
It has no legs, and that is deliberate. A cauldron on three legs has to carry the whole underside of its bowl over the gaps between them, and that underside is a roof with nothing beneath it — the one shape a printer cannot do dry. Every legged cauldron you can print either wants support or cheats with a solid slab between the legs. This one stands on a flared foot instead, which reads the same from across a room and prints on its own.
The wavy rim is cut from above, with spheres dropped onto the edge. Cutting downwards is what keeps it printable: whatever is left behind has its cut faces pointing up, and an upward face never needs anything underneath it. Scalloping the rim the other way round — adding drips onto it — hangs material in mid-air. The bites differ from one another so the edge reads as overflow rather than as a pie crimp, and they follow a fixed pattern rather than a random one, so the same settings always give you the same bowl.
About the wall angle. The steepest the wall leans is 60 degrees from vertical, at the flare of the lip. That is past the 45 degree rule and it does not matter: 45 is the rule for a solid, and this is a 2.4 mm shell. What a shell cares about is how far one ring of wall steps sideways off the ring below, and at 60 degrees and a 0.2 mm layer that step is 0.35 mm against a 2.4 mm wall — the new ring lands on six sevenths of the old one.
Parametric. Every diameter and every height along the profile, the rounding at the foot, belly, shoulder and lip, the wall and floor, and the rim: how many bites, how deep, how big, how uneven. Make it a squat cauldron or a tall stockpot.
Printing. No support, no raft. 0.2 mm layers, 3 walls, 10% infill — and turn auto-support off, because most slicers flag anything past 30 degrees and will build a tower inside the bowl that the shape does not need. The 3MF here already has it switched off. Measured on an A1 in PLA at 0.2 mm: 1 h 36 min and 80.5 g.
Not vase mode — it needs its floor.