1 / 1
Olfa L-1 (18mm - 3/4") wall holder
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A very simple utility knife holder fit for the Olfa L-1. It fastens with one #6 (or equivalent) countersunk screw.
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 2
- Makes
- 0
- Views
- 18
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Organizers
- License
- Creative Commons — Attribution — Noncommercial
After searching for simple wall holders for an Olfa knife, I wasn't satisfied with anything. They all either held the knife from one end or were dependent on how far the fastening knob was on the knife.
This hook cradles the knob with a brand new blade fully retracted and the knife can be taken out without having to slide it out of a full loop.
Printing
Print it as oriented in the file. You might need a brim but I didn't. It prints without supports.