1 / 1
Sabot for shooting .585 balls from a CAL-16 rifle — image 1

Sabot for shooting .585 balls from a CAL-16 rifle

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Sabot for shooting .585 balls from a CAL-16 rifle

Rating
0 / 5
Likes
1
Downloads
7
Makes
0
Views
43
Reviews
0

Updated at source:

Model information

Category
Other Sports
License
Open Community License v1.1

This is a sabot for shooting .585 balls from a CAL-16 rifle. It fits the choke because of the tiny drive bands which fall of at the choke.

I use leftover pieces of PETG and PLA to make these. When shooting with blackpowder its advised to use a hardcard or cork layer between the sabot and the powder to avoid melted plastic in the barrel. For nitro powder us a plastic separator.

You need to print 3 for each cartridge. Freecad file is included in case you want to change anything.

WARNING: Always test and measure projectiles before you shoot anything. I tested everything very well but not all 3D printers and materials are the same, just be careful. I dont take any responsibility if something goes wrong.