Circus Elephant - Kit Card (2 Colours, Slot-Together, No Glue)
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Snap-out kit card that slots together into a circus elephant. 2 colours, no AMS needed, no glue, no supports.
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 1
- Makes
- 0
- Views
- 4
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Building Toys
- License
- Creative Commons — Attribution — Noncommercial
A 120 x 80 mm kit card, printed flat in one go. Snap the parts off the frame and slot them together into a circus elephant with a curled trunk, tusk, decorated blanket and big flappy 3D ears, standing on four legs, plus a circus ball. No glue: everything joins with tight cross-lap slots.
FEATURES
Built size: about 56 x 35 x 43 mm
2 colours: start in grey, finish in pink or red
Prints flat with no supports, no AMS needed
About 11 g of filament
Part of a series of kit cards, collect them all
PRINT SETTINGS
The 3MF is ready to print: 0.2 mm layers, 7% gyroid infill, tree supports set to auto. The card prints flat, so no supports are actually generated
The parts are only 1.8 mm thick, so they come out almost solid
2 colours: the 3MF has 2 parts, a grey body and pink raised details, assigned to 2 filaments for AMS / multi-material printers
No AMS? Print the body in grey, add a filament change at 1.8 mm, then finish in pink or red
Use a 0.4 mm nozzle
ASSEMBLY (raised side facing you)
Snap the parts off the frame at the small gates, and trim any nubs.
Push the front and rear leg pieces up into the slots under the body, crosswise.
Push the ears piece down over the slot in the head.
Bonus: cross the two ball halves to make a circus ball.
TIPS
The slots are a tight fit: 1.75 mm wide for 1.8 mm parts, with a small lead-in at each slot mouth. Push the parts together firmly and straight.
Too tight for your printer? Sand or file the slot once, or print the card at 99% in Z.