1 / 6
Under-cabinet rest for Salter kitchen scales (fits a 32 mm downstand) — image 1
1 / 6

Under-cabinet rest for Salter kitchen scales (fits a 32 mm downstand)

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Holds flat kitchen scales under a wall cabinet, within its front lip, with nothing pressing on the weighing platform.

Rating
0 / 5
Likes
0
Downloads
0
Makes
0
Views
10
Reviews
0

Updated at source:

Model information

Category
Kitchen
License
Creative Commons — Attribution — Noncommercial — Share Alike

A bracket that screws under a wall cabinet and holds a flat kitchen scale there, out of the way, keeping the worktop clear.

Most under-cabinet racks have the scales slide into rails, which only works if there's room for the scales to pass under the cabinet's front lip. Mine has a 32 mm downstand along the front, so the old rack's scales couldn't come out. This one fits entirely within the downstand, and the scales come out by tipping:

  • Stored: the scales lie sideways on two lips along the rear 105 mm of each side (about 64% of the base). Nothing touches the top of the scales, so there's never any load on the weighing platform, and the feet hang in the air inboard of the lips.

  • Out: pull the scales forward. At about 25 mm the front sags into your hand; keep pulling and lowering, and at about 70 mm the front edge drops below the downstand and they slide out.

  • In: rear edge up at an angle onto the lips, level, push back to the rear bar.

Made for Salter digital scales 200 × 165 × 20 mm. The OpenSCAD file is included and parametric: set your scales' width, depth and thickness and your cabinet's downstand height, and it re-checks the tipping geometry when it renders. It prints whether the front corner clears the downstand at 65, 70 and 75 mm of pull, and stops with an error if the bracket is taller than the downstand or the centre of gravity is too near the lip end.

Status: printed, not yet tested in place. I'll update this once it's fitted.

Print settings

  • Printed on a Bambu P1S in PLA.

  • The STL stands on the rear bar: 121 mm tall, footprint 234 × 31 mm. Every section is a vertical extrusion and the screw holes print horizontal, so no supports. Use a brim.

  • Three walls, 15% infill. About 55 g.

Size

234 wide × 121 deep × 31 tall. 204 mm between the walls for 200 mm scales, 8.5 mm of headroom above them.

Fitting

  1. Rear bar against the wall, centred where the scales should hang.

  2. Mark the four holes through the flanges, drill 3 mm pilots, and screw it up with four 4 × 25 mm countersunk screws.

  3. Scales in sideways at an angle, rear edge first onto the lips, level, push back.

Tags