Firewalla Gold SE surface mount
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This is a surface mount bracket for mounting a firewalla gold SE to a wall or other flat surface.
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 2
- Makes
- 0
- Views
- 7
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Office
- License
- Creative Commons — Attribution — Noncommercial
This is a fairly simple design that I modeled up to be able to securely mount my Firewalla Gold SE router to the back of a desk without restricting airflow. As is often the case, I wasn't very happy with the available mounts designed by others. There are two threaded mounting holes on the base of the router that provide a simple mount point, so i just needed to make a bracket thick enough to countersink some screw heads in those locations and then provide mounting holes above and below the router. The result worked perfectly and I now have my router mounted in a safe location.
*I've added a v2 version with mirrored mounting holes so that the router can be mounted with either end upward while allowing the keyhole tab to remain at the top.
Any material will work for this but I think I believe I used ASA for mine, and provided the appropriate scale factor compared to PLA or PETG.
Special considerations:
Consider using (100% infill) modifiers at the screw attachment points to avoid crushing the material when tightening screws. You could also accomplish this by using extra perimeters if you prefer. If I'm remembering correctly the mounting screws were M3 or M4, but I don't have easy access to mine to confirm, so you'll have to verify on your own router.
You'll want to print this with the chamfered side down so that the router mount screw recesses on the top and thus will not require support.