HSW Sheet Holder (Heavier)
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A stiffer, stronger remix of the extended sheet holder. It holds binders, folders and sheets flat against your HSW.
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 0
- Makes
- 0
- Views
- 12
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Gadgets
- License
- Creative Commons — Attribution — Noncommercial
The original extended sheet holder works, but its 3 mm strap is too thin. Load it with anything heavier than a few loose sheets and it bows away from the wall and lets go. This remix keeps the original hex plug exacty as it was, so it fits and locks into the wall the same way, and swaps in a much beefier strap.
What’s different:
Strap is 5 x 18 mm instead of 3 x 14 mm, which makes it roughly 6x stiffer and 3.5x stronger in bending
Same ~180 mm reach from the plug
Rounded tip with a lead-in chamfer on the inside face, so sheets slide under it instead of catching
Original plug geometry is unchanged
Still prints flat with no supports
Two versions:
Standard gap: same clamp gap as the original. Good for sheet protectors, thin folders and loose paper.
+5 mm gap: clamp gap is 5 mm deeper, with a fillet at the root. Use this for thicker binders or stacks.
This version doesn’t flex the way the original did. If you jam a stack that’s too thick under the standard version, the force goes into the plug instead of the strap. For thick stuff, print the +5 mm version.
Use two or more holders side by side for anything wider than a sheet of paper.
Print settings:
Material: PETG recommended. PLA works, but under constant clamping load it can creep and crack at the root over time.
Orientation: flat, as provided
Walls: 4 or more (at 5 mm thick the strap ends up mostly solid anyway)
Infill: 20 to 40%, your choice
Supports: none