1 / 1
Hooded exhaust cover for eSUN eBox Pro — image 1

Hooded exhaust cover for eSUN eBox Pro

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Humidity exhaust cover for the eSUN eBox Pro drybox

Rating
0 / 5
Likes
0
Downloads
2
Makes
0
Views
11
Reviews
0

Updated at source:

Model information

Category
Accessories
License
Creative Commons — Attribution — Share Alike

This is a replacement exhaust cover for the eSUN eBox Pro dryer.

When a fan pushes hot air through an open vertical chimney, the heat escapes straight up instantly.  Adding a small roof or a "hooded vent" over the hole is a highly effective upgrade for this heated drybox.

Forcing the air to exit horizontally instead, brings the following benefits:

  • Traps the Heat inside the drybox for longer: Hot air naturally wants to rise vertically. A roof forces the air to move sideways first, creating a tiny buffer zone. This lets the drybox vent the moisture without completely dumping its internal temperature.

  • Maintains Internal Pressure: Because the box has a fan, it creates a slight positive pressure. Forcing the air through a hooded bend ensures that only the highly pressurized, wet air escapes, rather than letting ambient heat passively bleed out.

  • Dust & Debris Protection: It prevents dust, stray filament strands, or accidental spills from falling straight down through the hole and onto the spool while the box is sitting on your desk.

To install it, remove the standard rubber grommet and screw-in the new hooded vent cover.

Note: because this hood will sit right in the path of escaping hot air, do not print it out of standard PLA. If your drybox heats up to dry tough filaments, such a PLA cover would warp and droop over time.