guition 4inch display mount for EU wall socket
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
3D-printed adaptor mounts the Guition 4" ESP32-S3 display flush on a 68 mm EU wall box, 2 mm bezel, snap-fit.
- Rating
- 0 / 5
- Likes
- 3
- Downloads
- 22
- Makes
- 0
- Views
- 80
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Wall-mounted
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Wall-mount adaptor for the Guition 4848S040 (4" ESP32-S3 display)
This adaptor lets you mount the Guition 4" display straight onto a standard 68 mm EU wall socket, so it sits flat against the wall with just a 2 mm bezel. It’s sized around the display’s frame and connectors, which keeps the fit snug and the result clean and tidy.
Fits standard 68 mm EU in-wall boxes
Slim 2 mm bezel, so it looks flush and modern
Mounts directly to the wall, no extra plates needed
All internal connectors exposed; easy to connect to (like internal power)
Easy to remove; small openings along the bottom let you slip in a screwdriver and pop the screen out whenever you need to
Easy to print on an FDM printer, with minimal supports (only on snap-on studs)
How to install
Screw the adaptor into the wall box using the standard screw points. Make sure the text is not up-side-down
Remove the back-plate of the display (two small screws)
Connect the power to the internal pin-header (mains to low voltage converter required)
Snap the display's top onto the adapter top with an angle
Press down on the bottom until it clicks
How to remove
Slide a screwdriver into the openings at the bottom and gently pry the screen out. No tools needed beyond that, and no damage to the display or the adaptor