Fiido D3 Pro bike Power Plug repair plate
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Fiido 3D bike. Repair plate for re-embedding the brass threads for the charging connector.
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 1
- Makes
- 0
- Views
- 7
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Mechanical Parts
- License
- Creative Commons — Attribution — Noncommercial — NoDerivatives
Reparaturplatte, falls ein oder zwei der Gewindehülsen nicht mehr halten. In diese Platte werden die Messinggewinde wieder eingeschmolzen und die Ladebuchse ist wieder fest.
1. An dem ausgebauten Deckel an der Innenseite die beiden Kunststoff Verstärkungen der ausgerissenen M3 Messinghülsen entfernen und mit einem Cuttermesser flach abschneiden.
2.Die aus ASA gedruckte Reparaturplatte von innen mit Sekundenkleber ankleben.
3.Die Messinggewinde wieder einschmelzen.
4. Ein/Aus Taster und Ladebuchse montieren und das Gehäuse am Fiido 3D Pro Fahrrad mit 4 Schrauben wieder befestigen.
1. Use a utility knife to cut away the two plastic reinforcements—where the M3 brass threaded inserts were torn out—so that the surface is flush.
2. Insert the 3D-printed ASA repair plate from the inside using superglue.
3. Re-embed the brass threaded inserts (by melting them back into place).
4. Install the on/off button and the charging port, then reattach the housing to the Fiido 3D Pro bike using 4 screws.