Weighted Star Stocking Holder for Mantel

Weighted stocking holder for a fireplace mantel: a faceted gold star stuck into a snowdrift block, with a gold J-hook for the stocking. The snow block (84 × 80 × 32 mm) has a threaded compartment underneath – fill it with coins, steel shot or sand and close the screw cap, so the holder won't tip over. The hook's tongue slides into a channel under the block and is clamped by its weight; fits mantels at least 80 mm deep. 4 parts in 2 colors (white block + cap, gold star + hook), all push-fit – no glue, no screws in your mantel. Prints without supports in PLA or PETG at 0.2 mm; print several for the whole family.

Parts

• Obciaznik na skarpete na kominek bezbajzlu - podstawa.stl x 1

• Obciaznik na skarpete na kominek bezbajzlu - zakretka.stl x 1

• Obciaznik na skarpete na kominek bezbajzlu - gwiazda.stl x 1

• Obciaznik na skarpete na kominek bezbajzlu - hak.stl x 1

Print settings

• Bambu Lab A1, 0.4 nozzle, PLA Matte (or PETG), 0.20 mm layer

• Colors: warm white, silk gold

• No supports needed

• Full set: 2 h 29 min, 84 g (2 plates)