Audi A2 Ultrasonic Alarm Disable B-Pillar Switch Repair Clip Version 2
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Designed to repair the broken tabs on the B-Pillar switch, version 2 brings several improvements.
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 4
- Makes
- 0
- Views
- 17
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Automotive
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Designed to repair the broken tabs on the B-Pillar switch, version 2 fixes a mistake in the first version that sometimes leads to failure, and also expands the design to include the white plastic piece that is often lost due to getting shot out when the switch cap comes off.
This is specifically for the Alarm button, the fuel button version can be found on my profile.
PLA is not suitable due to it's tendency to ‘creep’, the clip failed after a few days.
I print with ASA or ABS, 0.4mm nozzle, 0.2mm layers, 240 degree nozzle temp, 105 degree bed temp, custom supports under the prongs/arms, and a brim to help hold the main face vertical during printing.
Make sure that the arms are printed horizontal or they will snap along the layer lines.
Printing in batches helps the layers cool in time, as it is a small part.
If the original spring is used, then the switch becomes stiffer due to the extra preload created by the thickness of the repair part, to create the closest feel to the factory switch a slightly weaker spring must be used.
Instructions are available on the A2oc, linked below: