1 / 4
Metal barrel for Triton — image 1
1 / 4

Metal barrel for Triton

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Triton mod to accept a metal barrel

Rating
0 / 5
Likes
19
Downloads
25
Makes
0
Views
197
Reviews
0

Updated at source:

Model information

Category
Outdoor Toys
License
Creative Commons — Attribution — Noncommercial — Share Alike

A remix to allow Bruce Leedle's Triton to accept a 16 mm barrel. Will also need two 016 o-rings to seal the barrel, which will need to be installed before assembling the front half of the blaster. Also modified the the pusher head to take 2x 012 o-rings.

A 268 mm barrel will sit flush with the barrel nut, just add how ever much barrel extra is needed for your attachment of choice.

Or a 240 mm barrel if you'd like to run a short barrel, leave out the barrel nut, and print a short collet M0053 B1T3, the 9 bearing with m3 screws is whats pictured 

From some of my testing using 4 mm cord...3x individual cords, 2 were fairly tight and one not quite as tight, much easier prime than before and averaging about the same as the harder prime on the stock printed barrel, 300 mm x 13 mm barrel, after 30x darts...average was 223.6...highest was 230.2 and lowest was 217.3

Cut the looser cord, leaving the two tight cords leaving a crazy easy prime, same barrel, 30x darts...average was 186.6...highest was 190.5 and lowest was 181.2...

tried my 450 mm x .509 barrel and was easily losing 20-25 fps on both cord set ups

I did manage to one hand prime, no stock, with 2 cords re-tied "sorta" tight and was getting 150-160 with a 240 mm x 12.4 ID barrel and bcar. Will do more testing when some new cord comes in