1 / 4
Star Curtain Rod Finial - 2-Color Glue-On Set, 5 Rod Sizes — image 1
1 / 4

Star Curtain Rod Finial - 2-Color Glue-On Set, 5 Rod Sizes

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Faceted star curtain rod finial. Two parts, printed in two colors and glued. Five rod sizes: 16, 19, 22, 25, 28 mm.

Rating
0 / 5
Likes
0
Downloads
0
Makes
0
Views
4
Reviews
0

Updated at source:

Model information

Category
Home Decor
License
Creative Commons — Attribution — Noncommercial

A faceted star finial for curtain rods and towel rails. Two simple parts: print the star in one color and the tube in another, then glue them together. No multi-color printer or AMS needed. The tube slides over the end of your rod. Five sizes: 16, 19, 22, 25 and 28 mm rods.

HOW IT WORKS

- Two parts: a star and a tube, each printed in its own color, then glued.

- The back of the star has a curved groove that matches the outside of the tube, so the glue joint is a wide surface, not just a line.

- The tube is closed at one end (3 mm end cap) and open at the other. The rod slides in from the open end and stops at the cap, so the end looks clean.

- Star is about 79 x 75 mm. Tube is 88 mm long.

SIZES (tube inner diameter = rod diameter)

- 16 mm rod: tube ID 16.2 mm, OD 25 mm

- 19 mm rod: tube ID 19.2 mm, OD 28 mm

- 22 mm rod: tube ID 22.2 mm, OD 31 mm

- 25 mm rod: tube ID 25.2 mm, OD 34 mm

- 28 mm rod: tube ID 28.2 mm, OD 37 mm

Wall thickness is 4.4 mm on every size. Only the 19 mm set has been printed and tested so far. The 16, 22, 25 and 28 mm sizes come from the same model but have not been test-printed yet.

FIT TIP

The inner diameter has only 0.2 mm clearance. If your printer runs tight, scale the tube by 101% or ream the bore lightly. Measure your rod first.

FILES

Each size has a Star STL and a Tube STL (for example StarTowelCap_ID19.2_Star.stl and StarTowelCap_ID19.2_Tube.stl). Both parts share the same origin, so they line up if you import them together in your slicer.

ASSEMBLY

1. Print both parts.

2. Check that the tube slides over your rod.

3. Glue the star onto the tube, seating the tube in the groove on the back of the star. Cyanoacrylate (super glue) works well on PLA and PETG; roughen both surfaces lightly first.

4. Slide onto the rod, closed end outward.

HARDWARE: glue only. No screws.

PRINT SETTINGS (recommended starting values, not a record of a specific test print)

- Material: PLA or PETG, one color per part

- Layer height: 0.2 mm, 3 walls, 15-20% gyroid infill

- Tube: stand it upright, closed end down on the bed, open end up. No supports needed.

- Star: flat back on the bed. The curved groove on the back is an arch overhang: use supports for the groove only, or try without.

Tags