Paracord & Guy Line Winder + 4 Tent Rope Tensioners – Camping Cord Organizer
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Flat paracord/guy-line winder with lock slits + 4 three-hole tent tensioners. Flush orange inlay, no supports.
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 1
- Makes
- 0
- Views
- 16
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Outdoor Sports
- License
- Standard Digital File License

Keep tent guy lines and paracord tangle-free and ready to deploy. This set has one flat cord winder and four classic 3-hole guy-line tensioners. Everything packs flat in your camping kit.
Winder features:
- U-notches at both ends: wind cord lengthwise and it stays put
- 4 angled cord-lock slits on the long edges that pinch the loose end so the bundle never unravels: 2 sized for 550 paracord, 2 for thin guy line
- Clip hole for a carabiner, backpack strap or keyring
- Safety-orange chevrons and an orange ring around the clip hole so it is easy to spot in grass, sand or a dark gear bag. These are flush two-color inlays, with no paint or sticker to wear off and no text or logo.
The 3-hole tensioners are the proven runner style: tie the line to the first hole, loop it around the stake, then thread it back through the other two. Slide to tighten; friction holds the tension. Their orange end caps make them easy to find when you strike camp.
Key dimensions (measured from the model, mm):
- Winder: 130.0 x 62.0 x 5.0 (about 5.1 x 2.4 x 0.2 in), corner radius 8
- End notches: 24.0 wide x 22.0 deep (R12 bottom); 86.0 between notch bottoms
- Capacity (estimate): about 7 m / 22 ft of 550 paracord (Ø4) or about 16 m / 53 ft of Ø2.5 guy line
- Paracord lock slits: 2.8 to 2.0 wide, 12 long, 45°; guy-line lock slits: 1.8 to 1.2 wide
- Clip hole: Ø9.0 with an orange ring (OD 14.0)
- Tensioner (x4): 44.0 x 14.0 x 4.0, three Ø5.0 holes at 13.0 pitch, for cord about 2.5–4 mm
- Colors: forest green body (#2E6B3F) with safety-orange (#FF8C1A) flush inlay, 0.6 deep
- Prints flat with no supports. On a Bambu Lab H2D the whole set takes 0h50m and 28.1 g of PLA (sliced result).
For long outdoor UV exposure, choose PETG or ASA. Custom slit and hole sizes are available for other cord diameters.