Hypercube BLTouch Mount
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This is a remix of the capacitive proximity sensor mount into a BLTouch mount. It should hold the sensor (not…
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 18
- Makes
- 0
- Views
- 187
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Printer Parts & Upgrades
- License
- Creative Commons — Attribution — Share Alike
This is a remix of the capacitive proximity sensor mount into a BLTouch mount. It should hold the sensor (not including the pin) 8.3 mm above the print bed when the nozzle is on the bed.
In your Marlin config, start with NOZZLE_TO_PROBE_OFFSET set to {25,0,-2}, home the printer, get the Z position (probably greater than 0) where a piece of paper drags a bit when pulled between the nozzle and bed, and add that to -2 to get the proper Z-value for probe offset
Print Settings
Printer:
Hypercube 300
Rafts:
No
Supports:
No
Resolution:
0.2 mm
Infill:
15
Filament:
eSun PLA+
fire-engine red
Category: 3D Printer Parts