1 / 4
LM8LUU/LM8UU Bearing Removal and Installation Tool — image 1
1 / 4

LM8LUU/LM8UU Bearing Removal and Installation Tool

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

A simple tool to press bearings out of (and back into) mounts, housings, etc. I needed to replace one of the…

Rating
0 / 5
Likes
2
Downloads
51
Makes
0
Views
576
Reviews
0

Updated at source:

Model information

Category
Tools
License
Creative Commons — Attribution

A simple tool to press bearings out of (and back into) mounts, housings, etc. I needed to replace one of the X-carriage mounts on my A8 to accommodate a replacement idler pulley that was wider than the original; this made quick work out of removing the LM8LUU bearing from the original mount. I had already pressed a replacement bearing into the replacement mount, but I suspect this would've also worked well to install the bearing. A few light taps with a small hammer on the plastic rod is all it takes.

I sized this for the LM8LUU bearing in an Anet A8 X-carriage mount. You can tweak the OpenSCAD file for other sizes; I'd recommend sizing the rod 1 mm under your bearing's nominal outer diameter and the cylinder 1 mm over. You should be able to print them at the same time.

Print Settings

Printer:

Anet A8

Rafts:

No

Supports:

No

Resolution:

0.2 mm

Infill:

40%

Category: Tools

Tags