Chop saw for Silverline flexible shaft
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
All I did was split the original STL (with both pieces) into two pieces so that each piece can be properly aligned on…
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 10
- Makes
- 0
- Views
- 177
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Tools
- License
- Creative Commons — Attribution
All I did was split the original STL (with both pieces) into two pieces so that each piece can be properly aligned on the print bed (in the original, the bottom could only be printed vertically, and supports would've been needed for the slot).
Use a 5" length of 5/16" threaded rod in the hinge, with nuts and washers as shown. (M8 rod might also work (it's only about 2.46 mils larger), but it's not readily available in stores here.)
(I almost cut the rod from a 3' length with another 3' rod temporarily installed, but the cutting discs that came with my rotary tool were too small. I need larger discs, or a suitable blade if it exists.)
Print Settings
Printer:
Anet A8
Rafts:
No
Supports:
No
Resolution:
0.2 mm
Infill:
40%
Notes:
I used opaque black PETG for this.
Category: Tools