Window Flower Box with 3 Flowers - Multi-Part, No AMS Needed
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Small decorative window planter with 3 pegged flowers. Separate single-colour parts: no AMS, no supports needed.
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 1
- Makes
- 0
- Views
- 7
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Pets
- License
- Creative Commons — Attribution
A small decorative window flower box with three flowers, made for my cat Woody's outdoor house. It fits under a 166 mm wide window frame.
Matching window frame with shutters: https://www.printables.com/model/1894863-cross-window-frame-with-shutters-multi-part-no-ams
More pieces from the same house: wall lantern https://www.printables.com/model/1901505 and wall mailbox https://www.printables.com/model/1901507
Every part is a separate single-colour file, so you can print it in several colours without an AMS or manual colour changes. Everything prints flat, without supports.
Parts (suggested colours):
Planter box, 120 x 40 x 35 mm (white)
Brackets x2 (grey)
Soil insert with 3 square holes (black)
Stems with leaves x3 (green)
Large 5-petal flower (red)
Small 6-petal flowers x2 (pink)
Flower centres x3 (gold)
Assembly:
The soil insert rests on a chamfered ledge inside the box.
Each stem has a 3 x 3 mm square tenon that plugs into the soil, with a collar so it cannot fall through.
Each flower clips onto the small pin at the top of its stem, and the centre sits in a recess in the middle of the flower.
All fits have 0.3 mm clearance. A drop of CA glue secures everything.
Glue the box to the wall with the two brackets underneath, about 40 mm on each side of the centre.
Print settings: PLA or PETG, 0.2 mm layers (0.15 mm for the flowers), 15-20 % infill, brim recommended for the flowers.
The window frame and shutters shown in the pictures are a separate model (link above).